| »Back to Peugeot
Index
PEUGEOT 206 PLIP - Remote Key
Programming
CENTRAL
DOOR LOCK (1 BUTTON PLIP KEY)
1. Ensure all the doors
are unlocked using the key.
2. Press and hold the plip key button
until the LED stops flashing.
3. After releasing the button,
the LED will light constantly.
4. Press the Plip Button once, and the LED
will extinguish.
5. Open the door and hold the Plip key near the
Ignition switch, and press the plip button one time.
6. Turn the ignition ON, and wait 10 seconds,
then turn ignition OFF.
7. After 5 seconds the Plip should now
operate.
CENTRAL DOOR LOCK with
DEADLOCKING (2 BUTTON PLIP KEY)
1. Ensure all doors are
unlocked using the key.
2. Press and HOLD the large plip key button
while the LED flashes continuously for 20 seconds. After 20
seconds press the small deadlock button once while still
holding the large button.
3. The LED will stop flashing.
4. Release the large button and the LED will
light constantly.
5. Press the large button once and the LED will
go out.
6. Open the door and hold the Plip key near the
Ignition switch and press the large plip button once.
7. Turn the ignition ON, wait 10 seconds
and then turn the ignition OFF.
8. After 5 seconds the Plip should now
operate.
206 PLIP PROGRAMMING SYNCHRONISATION—BSI
1. Insert the Ignition
Key.
2. Press the small Black button.
3. Switch the Ignition ON
4. Keep the lock button pressed for 10
seconds.
5. Release lock button , switch ignition OFF
and remove key.
6. Close all doors and press the lock button 2
times.
NOTE : If PLIPS still do not work, start the
vehicle and then turn OFF. Open and close the door, and check
PLIP again.
|