Megane Remote Plip Programming
MEGANE RF RESYNCHRONISING
Hold the remote control button down for longer than 10 seconds (until the red tell-
tale light on the key extinguishes) then press it again 3 times.
Check that the doors lock and unlock correctly.
MEGANE WITH EARLY REMOTE (LED SWITCHES OFF WHEN HOLDING
1. Igniton ON
2. Press and hold the central locking button for 5 seconds
3. LED on the dash board will go off, come back on and begin to flash.
The flashes correspond to the first digit of the 4 PIN security code- re-
lease the button when the first digit has been "flashed" and then press
the button again.
4. Wait for the second digit to be "flashed" then release and re-press the
button- continue until all digits have been entered.
5. If you have entered the code correctly the LED will then go out and the
car can be started- to code the remote, switch off the ignition and
press the central locking button again.
6. Press remote button 2 times within the immediate vicinity of the pick
up (in the roof) On some vehicles you may need to switch the ignition
back on to achieve this however.
by programyourkeys.com -